Rinse Aid; Setting Amount Of Rinse Aid; Switching Off Rinse Aid Refill Indicator - Gaggenau DI261 Instruction Manual

en

Rinse aid

Rinse aid
As soon as the low rinse-aid indicator H is lit on the
Ri n s e a i d
control panel or is requested on the front display * ):,
rinse-aid should be topped up. The rinse aid is required
for stain-free utensils and clear glasses. Use only rinse
aid for domestic dishwashers. Combined detergents
with rinse-aid component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke, 3.7 mmol/l)
only. If the water hardness is over 21° dH, rinse-aid
must be used.
* depending on the features of your dishwasher
Top up the rinse-aid as follows:
1. Open dispenser 9"; press lug on the lid (1) and lift
(2).
2.
Add rinse-aid up to the max. mark.
3.
Close the lid.
Lid "clicks" into position.
4.
Remove overflowed rinse aid with a cloth.
This prevents excessive frothing during the next rinse
cycle.
14

Setting amount of rinse aid

The amount of rinse aid to be dispensed can be set from
0 to 6. Set the amount of rinse aid to be dispensed to 5
to obtain a very good drying result. Do not change the
amount of rinse aid unless there are streaks or water
stains on the utensils. Set a lower level to avoid streaks.
Set a higher level to avoid water stains.
Set the amount of rinse aid as follows:
1.
Open the door.
2. Switch on ON/OFF switch (.
3. Press Info button { 8 for 3 seconds until the
following text is indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4. Keep pressing button > )* until the rinse aid
dispenser is indicated on the display window at the
top @.
5. Make the setting with setting buttons + - X.
Press and hold the Info button {8 for 3 seconds.
6.
The chosen setting has now been stored.
Switching off rinse aid refill
indicator
If the use of combined detergents with a rinse-aid
component impairs the low rinse-aid indicator H on
the control panel or the text on the front display * ):
(enough rinse aid for x rinse cycles), the displays can be
switched off.
Proceed as described under "Setting amount of rinse
aid" and select setting 0.
* depending on the features of your dishwasher