Gaggenau DI261 Instruction Manual page 35

Fault
Refill indicator for salt P and/
or rinse-aid H is not lit.
Water is left in the appliance at
the end of the programme.
Utensils not dry.
Plastic utensils not dry.
Cutlery not dry.
Appliance interior wet after rinse
cycle.
Cause
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under the filters
1Z is blocked.
Program has not ended yet.
No or too little rinse aid in the
dispenser.
Programme selected without drying.
Water collecting in depressions on
the utensils and cutlery.
The combined detergent used has
a poor drying performance.
ExtraDry to increase drying not
activated.
Utensils were removed too early or
drying process had not ended yet.
The eco rinse aid used has a limited
drying performance.
Door does not open automatically at
the end of the Eco 50° programme.
Door gap is not set correctly.
Special properties of plastic.
Cutlery not arranged properly in the
cutlery basket.
Cutlery not arranged properly in the
cutlery drawer.
No appliance fault.
Fault, what to do?
Remedial action
Activation/deactivation (see chapter "Water
softening system/Special salt" or "Rinse
aid" ).
Check refill indicator, levels.
Clean filters and area underneath.
Wait until programme ends or reset.
Refill rinse aid.
Select programme with drying.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate ExtraDry.
Wait until program ends or wait until 30 min
after program ends before removing
utensils.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Set the door correctly with the aid of the
installation instructions so that the door gap
is min. 70 mm - 150 mm.
Plastic has a lower heat storage capacity
and therefore dries less well.
Separate cutlery if possible, prevent contact
points.
Arrange cutlery properly and separate if
possible.
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
en
35