Operating The Appliance; Programme Data; Changing The Settings; Aquasensor - Gaggenau DI261 Instruction Manual

Operating the appliance

Programme data

Oper a t i n g t h e a p pl i a n c e
The programme data (consumption values) can be found
in the summary of instructions. They refer to normal
conditions and the water hardness set value °E 16 - 20
medium. Different influencing factors such as water
temperature or line pressure may result in deviations.

Changing the settings

The dishwasher has been preset with certain settings
for your convenience. You can change these factory
settings.
Change the setting as follows:
1.
Open the door.
Switch on ON/OFF switch (.
2.
3. Press Info button {8 for 3 seconds until the
following text is indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4.
Keep pressing button >)* until the required setting
is indicated on the display window at the top @.
5.
Make the setting with setting buttons + -X.
Press and hold the Info button {8 for 3 seconds.
6.
The chosen setting has now been stored.
Tip: If you change several settings, first make all
changes in succession. Now press the Info button
{ 8 for 3 seconds. This saves all set values in the
appliance.

AquaSensor *

* depending on the features of your dishwasher
Aqua S ens o r
The Aqua sensor is an optical measuring device (light
barrier) which measures the turbidity of the rinsing
water.
The AquaSensor is used according to the programme. If
the AquaSensor is active, "clean" rinsing water can be
transferred to the next rinse bath and water
consumption can be reduced by 3–6 litres. If
the turbidity is greater, the water is drained and
is replaced with fresh water. In the automatic
programmes the temperature and running time can also
be adjusted to the degree of soiling.

Time display

The running time is determined during the programme
by the water temperature, the number of utensils as well
as the degree of soiling and may vary (depending on the
selected programme). You can change the time display
in time or hours/minutes so that the remaining running
time of the rinsing progamme appears in the display
window "Ready at" (for example 15:20 hours) or "Ready
in" (for example 3:25).

Sensor setting

The programme sequence is optmised in Auto
programmes with the aid of sensors. The sensors adjust
the programme strength of Auto programmes depending
on the amount and type of soiling. You can adjust the
sensitivity of the sensors in 3 stages.
Standard: This setting is ideal for a mixed load and
heavily soiled utensils, but also saves energy and water.
Sensitive: This setting adjusts the programme strength
for the effective removal of food remnants, even if the
amount of soiling is low. The energy and water
consumption is adjusted accordingly.
Very sensitive: This setting adjusts the programme
strength for difficult conditions of use, for example
firmly dried on food remnants. This setting is
recommended if using biological or eco detergents
which contain lower amounts of active agents. The
energy and water consumption is adjusted accordingly.
Operating the appliance
en
27