Using Special Salt; Detergent With A Salt Component; Switching Off Water Softening System - Gaggenau DI261 Instruction Manual

Using special salt

As soon as the low salt indicator P is lit on the control
panel or is requested on the front display * ):, salt
should be topped up. Always refill with special salt
immediately before switching on the appliance. This
ensures that overrun special salt solution is immediately
washed out and does not corrode the rinsing tank.
Caution!
Detergent will destroy the water softening system! Never
pour detergent into the salt dispenser.
Top up the salt as follows:
Undo the screw plug on the dispenser 1R.
1.
2.
Fill the dispenser with water (required only when
switching on the appliance for the first time).
3.
Add salt as illustrated (do not use table salt or tablets).
The water is displaced and runs out.
* depending on the features of your dishwasher
Water softening system / special salt
Using detergents with salt component
I f combined detergents with a salt component
Det e r g ent wi t h a s a l t c o mponent
are used, special salt can usually be omitted up
to a water hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l). If the water hardness is over 21° dH, salt
must be used.
Switching off low salt indicator / water
softening system
If the use of combined detergents with a salt
Swi t c h i n g of f wa t e r s o f t e ni n g s y s t e m
component impairs the low salt indicator P on the
control panel or the text on the display window at the
top @ (enough salt for x rinse cycles), the displays
can be switched off.
Proceed as described under "Setting water softening
system" and set the value to 0-8. The water softening
system and salt refill indicator are now switched off.
en
13