HP A5120 EI Series Configuration Manual page 130

NOTE:
This feature is applicable only on hybrid ports.
Follow these steps to configure an IP subnet-based VLAN:
To do...
Enter system view
Enter VLAN view
Associate an IP subnet with the
current VLAN
Return to system view
Enter Ethernet
interface view
Enter Layer 2
Enter interface
aggregate
view or port
interface view
group view
Enter port group
view
Configure port link type as hybrid
Configure the hybrid port(s) to permit
the specified IP subnet-based VLANs
to pass through
Associate the hybrid port(s) with the
specified IP subnet-based VLAN
NOTE:
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it
fails to do that on an aggregation member port, it skips the port and moves to the next port.
Use the command...
system-view
vlan vlan-id
ip-subnet-vlan [ ip-subnet-index
] ip ip-address [ mask ]
quit
interface interface-type
interface-number
interface bridge-aggregation
interface-number
port-group manual port-group-
name
port link-type hybrid
port hybrid vlan vlan-id-list {
tagged | untagged }
port hybrid ip-subnet-vlan vlan
vlan-id
123
Remarks
—
—
Required
The IP network segment or IP
address to be associated with a
VLAN cannot be a multicast
network segment or a multicast
address.
—
Required
Use either command.

In Ethernet interface view,
the subsequent
configurations apply to the
current port.

In port group view, the
subsequent configurations
apply to all ports in the port
group.

In Layer 2 aggregate
interface view, the
subsequent configurations
apply to the Layer 2
aggregate interface and all
its member ports.
Required
Required
Required