HP A5120 EI Series Configuration Manual page 170

Frames of VLAN 250 through VLAN 350 can be exchanged between Customer B1 and Customer

B2 through VLAN 50 of the service provider network.
Figure 52 Network diagram for Basic QinQ configuration
Provider A
GE1/0/1
GE1/0/2
Configuration procedure
NOTE:
Be sure that you have configured the switches in the service provider network to allow QinQ packets to
pass through.
Configure Provider A.
1.
Configure GigabitEthernet 1/0/1

# Configure VLAN 10 as the PVID of GigabitEthernet 1/0/1.
<ProviderA> system-view
[ProviderA] interface gigabitethernet 1/0/1
[ProviderA-GigabitEthernet1/0/1] port access vlan 10
# Enable basic QinQ on GigabitEthernet 1/0/1.
[ProviderA-GigabitEthernet1/0/1] qinq enable
[ProviderA-GigabitEthernet1/0/1] quit
Configure GigabitEthernet 1/0/2

# Configure GigabitEthernet 1/0/2 as a hybrid port and configure VLAN 50 as the PVID of the port.
[ProviderA] interface gigabitethernet 1/0/2
[ProviderA-GigabitEthernet1/0/2] port link-type hybrid
[ProviderA-GigabitEthernet1/0/2] port hybrid pvid vlan 50
[ProviderA-GigabitEthernet1/0/2] port hybrid vlan 50 untagged
# Enable basic QinQ on GigabitEthernet 1/0/2.
[ProviderA-GigabitEthernet1/0/2] qinq enable
[ProviderA-GigabitEthernet1/0/2] quit
 Configure GigabitEthernet 1/0/3
# Configure GigabitEthernet 1/0/3 as a trunk port to permit frames of VLAN 10 and 50 to pass through.
Customer B1
Customer A1
VLAN 200~299
VLAN 250~350
VLAN 10, 50,
GE1/0/3
TPID = 0x8200
Public network
Customer B2 Customer A2
VLAN 250~350 VLAN 200~299
Provider B
GE1/0/1
GE1/0/3
GE1/0/2
163