Decode Settings; Imager Settings; Trigger Settings; Notification Settings - Honeywell Dolphin CT50 User Manual

Dolphin CT50 Mobile Computer User Guide

Decode Settings

Use the Decode Settings to scan bar codes that are densely packed.
When enabled, the scanner will only decode a bar code is part of it is at
the center of the aimer. Although you can adjust the Window
dimensions, Honeywell recommends leaving the settings at 50 to define
the "center" area for the bar code.
Decode Settings
Setting
Center Decode

Imager Settings

You should not need to modify the Imager Settings. The Override
Recommended Values setting is disabled by default. The recommended
Imager Settings are designed to work in a wide range of environments
and should only be modified if you have an advanced understanding of
imagers.

Trigger Settings

Use the Trigger Settings to configure how the scan buttons work.
Trigger Settings
Setting
Decode Timeout

Notification Settings

Use the Notification Settings to configure how your CT50 responds when
you scan a bar code.
Description
Enables the ability for the scanner to
scan only the bar code at the center of
the aimer.
Description
Scanning automatically turns off after this
number of seconds if the scan trigger is
pressed and nothing has successfully
decoded.
Chapter 3 — About the Scanner
Default
Disabled
Default
20
41