Table of Contents
Advertisement
4-2 HUMIDITY METER
1) Install the " Humidity Probe Plug " ( 3-12, Fig. 1 ) into the
" Humidity Socket " ( 3-13, Fig. 2 ).
2) Power on the meter by pressing the " Power Button "
( 3-2 , Fig. 1 ) once.
3) The display will show the humidity ( %RH ) and
temperature value that sening from " Humidity Probe Head "
( 3-10, Fig. 1) directly.
When the humidity values of tested environment be
changed, it need to take a few minutes to get the stable
" %RH " reading.
The humidity temperature unit is default to "
If intend change temperature unit to "
procedures please refer
5-3 Change the Temp
4-3 Thermometer
1) Connect the plug of the Temp. probe ( optional, such as
type K probe, TP-01, TP-02A, TP-03, TP-04 ) into the "
Thermometer socket " ( 3-14, Fig. 2 ).
2) Power on the meter by pressing the " Power Button "
( 3-2 , Fig. 1 ) once.
3)
The display will show the Temp. value that measuring
from the Temp. probe's head.
The thermometer mode is default to " type K ".
If intend change the Temp. mode to " type J " with
default, the detail procedures please refer
5-2 Change thermocouple type to K or J , page 14.
The temperature unit is default to "
temperature unit to "
The detail procedures please refer
5-3 Change the Temp
,
unit, page 14.
℃ ℉
℃
".
℉
,
unit, page 14.
℃ ℉
10
".
℃
", the detail
℉
", if intend change
Advertisement
Table of Contents
