Connector Board - HP ENVY Maintenance And Service Manual

Connector board

NOTE: The connector board spare part kit includes the audio jack, RJ-45 jack, USB port, and 2 cables.
Description
Connector board
Before removing the connector board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Base enclosure (see
Remove the connector board:
1. Disconnect the connector board cable (1) from the system board.
2. Release the connector board cable from the retention clips built into the top cover (2) and the subwoofer
(3).
3. Release the ZIF connector (4) to which the connector board ribbon cable is attached, and then
disconnect the connector board ribbon cable from the system board.
4. Detach the connector board ribbon cable (5) from the base enclosure. (The connector board ribbon cable
is attached to the top cover with double-sided tape.)
5. Remove the three Phillips PM2.0×2.9 screws (1) that secure the connector board to the top cover.
58 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 28), and then remove the following components:
WLAN module on page
Hard drive on page 31)
Base enclosure on page
29)
38)
Spare part number
765146-001