Base enclosure
Description
Base enclosure
Before removing the base enclosure, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
5.
Remove the solid-state drive (see
6.
Remove the hard drive (see
Remove the base enclosure:
1.
Remove the front rubber feet (1) and any additional screw covers.
The front rubber feet and the screw cover are included in the Rubber Kit, spare part number
720559-001.
38
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
28).
WLAN module on page
Hard drive on page
31).
Spare part number
774152-001
29).