Maintenance - S&P TL-10 N User Instructions

2. Put the appliance plug into a socket.
This unit is double insulated and no
carth connection is required.
3. Turn the thermostat knob in a
clokwise direction, to the maximum
position.
4. Select the Hetaing Power required:
Low Power 1.000 W, quiet mode;
Low Power 1.000W; High Power
2.000 W.
5. Once the desired temperature in
the room has been archieved, turn the
thermostat knob in an anticlockwise
direction until a soft click is heard
and the unit switches off. From then
on the heater will automatically select
the temperature.
6. Disconnection, turn the power knob
to the off position

Maintenance

1. Important, disconnect the unit from
the mains supply before carrying out
any maintenance operation.
2. Ever y season, clean the
accumulated dust from inside the unit
with a high pressure air jet or vacuum
cleaner. It is recommended that this
operation is carried out by a qualified
technician.
3. Clean the inlet and outlet grilles
regularly.
4. The appliance should not be dipped
in water for any reason nor should it
be put under a tap.
5. Do not dismantle the appliance in
any way as this will nullify the S&P
guarantee.
6. If the supply cord of this appliance
is damaged, it must only be replaced
by repair shop appointed by the
manufacturer because special
purpose tools are required.
Remark: it is very important that
regular maintenance of the fan
heater is carried out in order to reduce
the risk of possible fire hazards.
Overheating, switch off
In the event of overheating due to
any abnormal operation or failure, the
safety protection device will
automatically switch the unit off. In
this event:
1. Disconnect the appliance from the
mains supply.
2. Allow the unit to cool down for at
least 15 minutes.
3. Make sure that the outlet grille is
not obstructed by dust and if
necessary it can be cleaned with a
vacuum cleaner.
If after these actions the appliance
still does not work properly, we
recommend that it be taken to your
S&P dealer.
Removal from service,
disposal and recycling
- EU regulations and our commitment
to future generations oblige us to
recycle used materials; please re-
member to dispose of all unwanted
packaging materials at the appropriate
recycling points, and to drop off ob-
solete equipment at the nearest waste
management point.
230 V ~ 50 Hz 2.000 W
7