S&P TL-10 N User Instructions page 6

GB
User instructions
Read these instructions carefully
before using the appliance.
The fan heater TL-10 N is
manufactured in accordance with
European Standard EN-60335-2-30.
We recommend that you check the
unit immediately on un-packing to
ensure that it is in good condition and
that it works properly as any defect
duc to faulty workmanship or
materials is covered by the S&P
guarantee.
IMPORTANT INSTRUCTIONS
– The heater should not be situated
under a current trap.
– Do not use this heater near a bath,
shower or a swimming pool.
– Do not handle the heater with your
hands wet.
– This symbol means "Do not
cover" the heater with objects that
prevent the air circulating freely.
Obstructing the airflow increases
the risk of overheating.
– If the cable is damaged, it must be
replaced in one of our Oficial Services.
– Should flammable objets (curtains,
etc.) not be placed at less than 50 cm.
from the heat circuit.
– While the heater is in use, the cable
must not be placed in front of the air
outlet.
– Keep the air inlet and outlet grilles
always clean. The device must
be unplegged before starting the
maintenance works.
– This appliance is not intended for
use by persons, including children,
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision
or instruction concerning use
of the appliance by a person
responsible for their safety.
– Children must be under watch to
avoid that they could play with the
product.
– This appliance must not be used
connected to a programmer, timer
or another device that controls
heater connection automatically.
Power selection knob
Stop
Low Power Heating, quiet mode- 1.000 W
Low Power Heating- 1.000 W
High Power Heating - 2.000 W
Thermostat knob (B, fig. 1)
Maximum position of the thermostat
Minimum position of the thermostat
The thermostat controls the heater to
maintain the temperature selected bet-
ween minimum and maximum . When
selected room temperature is obtained
the thermostat will switch heater off,
and on, to maintain this setting.
Operation
1. Please ensure that the supply
voltage is in accordance with the
product rating plate (230 V 50 Hz).
6
(A, Fig. 1)