Help Guide | Turning The Power Off (Standby Mode) - Sony SRS-HG1 Help Manual

Help Guide
Personal Audio System
h.ear go (SRS-HG1)
Turning the power off (standby mode)
Press the (power)/
1
The (power) indicator flashes slowly in green. When the indicator lights up in red, the speaker enters the standby mode.
Hint
If you turn off the speaker when it is connected to an AC outlet via the USB AC adaptor, and while the BLUETOOTH/Network standby mode is on,
the (power) indicator lights up in orange and the speaker enters the BLUETOOTH/Network standby mode.
Note
If you turn off the speaker while the LINK indicator is flashing, the
malfunction. Wait until the indicator stops flashing. While the
stays lit.
If the speaker has been turned off for 30 hours without charging, it will enter the power saving mode, and the
cancel the power saving mode, press and hold the
outlet via the supplied USB AC adaptor and micro-USB cable. In this case, it will take about 15 to 30 seconds to start up the speaker. You cannot
make a BLUETOOTH connection between the speaker and another NFC-compatible device by one touch (NFC) when the speaker is in the power
saving mode. After the
Related Topic
Using the BLUETOOTH/Network standby mode
Auto standby mode
Standby mode differences
4-589-712-11(2) Copyright 2016 Sony Corporation
PAIRING button.
(power)/
(power) indicator starts flashing by turning on the speaker, touch with a smartphone again.
(power) indicator may flash for several tens of seconds. This is not a
(power) indicator is flashing, the speaker is not operational. Wait until the indicator
PAIRING button for more than two seconds, or connect the speaker to an AC
(power) indicator will be off. To
35