Table of Contents
Advertisement
Recording Simultaneously with the Internal VTR and an External
VTR
Connections
Checking the Function Settings
Starting Recording
If One VTR Comes to the End of its Tape During Recording
Mount the AJ-YA900P 26-pin/12-pin output adaptor (option) to the unit, connect the external
VTR with the 26-pin cable, and set the audio input level selector switch of the external VTR to
"p60 dB".
SW201 on the CAM ENC Printed Circuit Board of the unit must be set to ON side.
(See page 98.)
Audio input level selector switch: p60 dB
Portable VTR
(Set the audio input level
selector switch to p60 dB.)
Check that the settings of the functions which control the 26-pin interface are set to BOTH or
ON at the FUNCTION 3/5 page of the setting menu. See "Selecting Functions" for a description
of the various function settings.
1
Operate the external VTR and set it to recording paused status.
2
Press the VTR START button of the unit or the VTR button of the lens. The internal and
external VTRs start recording simultaneously. Pressing the button again sets both VTRs to
the recording paused status.
Even if one VTR comes to the end of its tape and stops, the other VTR continues recording op-
eration.
Returning the VTRs to simultaneous recording status
ÁIf the internal VTR came to the end of its tape, replace the cassette and press the VTR START
button of the unit or the VTR button of the lens. The external VTR continues recording opera-
tion during this time.
ÁIf the external VTR came to the end of its tape, replace the cassette and operate the external
VTR to restart recording. The internal VTR continues recording operation during this time.
|Note{
Care should be taken as the internal VTR will assume recording paused status if the VTR
START button of the unit or the VTR button of the lens is pressed after replacing the external
VTR's cassette.
To the 26-pin connector of the
AJ-YA900P (See page 98 for mounting the
26-pin/12-pin output adaptor)
– 96 –
Advertisement
Table of Contents
