Table of Contents
Advertisement
Setup Card Operations
Reading out data stored on cards
1
Set the MENU SET/OFF switch to SET. The page on which the previous setting menu oper-
ations were completed appears on the viewfinder screen. (When the menu is used for the
first time, the first page appears.)
2
Press the PAGE switch repeatedly until the SET UP CARD 1/2 page appears.
(This operation can also be performed using the PAGEoUP/DOWN function.)
3
Press the SHIFT/ITEM button to move the cursor to the READ position.
4
A menu shown below appears when the UP (or DOWN) button is pressed.
5
Press the UP button to read data from the set up card. When readout is complete, the mes-
sage shown below appears.
6
When menu operations have been completed, set the MENU SET/OFF switch to OFF. The
setting menu disappears from the viewfinder screen and the displays indicating the unit's
current status based on the data read out from the setup card appear at the top and bottom
of the viewfinder screen.
When data is not read out
If the following error messages appear when the UP button is pressed in step 5, the data is not
read out.
Data readout error messages
Error message
NO CONFIG
The setup card is not
formatted.
NO CARD
A setup card is not
inserted.
ERROR
Data cannot be read out.
- SE T UP CARD
READ
USER
READ
¢
SE L ECT
WR I T E
SE L ECT
C
ARD
C
ONF G
I
READ
? Y : UP N
(
,
: DO
- SE T UP CARD
READ
USER
READ
¢
SE L ECT
WR I T E
SE L ECT
C
ARD
C
ONF G
I
READ OK
Condition
– 86 –
1 / 2
-
D
A
T
A
0
0
W
N
)
1 / 2
-
D
A
T
A
0
0
Countermeasure
Format the card.
Insert a card.
Data written by devices
other than this unit cannot
be read out.
Advertisement
Table of Contents
