Table of Contents
Advertisement
Controls and Their Functions
Warning/Status Display Section
FThe viewfinder is an op-
tional accessory with
the AJ-D900WA.
(The viewfinder in the
illustration
is
the
AJ-VF10P.)
"
"
TCG (time code selector) switch
This is used to set the running mode of the internal time code generator.
F-RUN: This position is used when the time code is to be advanced continuously regardless
of the VTR's operation.
Set to this position when aligning the time code with the actual time or locking the
time code to an external source.
SET:
This position is used for setting the time code or user's bit.
R-RUN: This position is used when the time code is to be advanced only while recording is
in progress. The time code will be recorded continuously on a tape with a succes-
sion of unedited shots.
Tally lampF
This is activated when the TALLY switch
by the VTR section. It flashes in the same way as the REC lamp inside the viewfinder to warn
the operator. The brightness when lighted can be selected using the TALLY switch (HIGH or
LOW).
TALLY switchF
This controls the tally lamp
HIGH: The tally lamp is made brighter.
OFF: The tally lamp is extinguished.
LOW: The tally lamp is made darker.
Back tally lamp
This functions in the same way as the tally lamp
ON.
Back tally switch
This controls the back tally lamp
ON: The back tally lamp operates.
OFF: The back tally lamp does not operate.
WARNING lamp
This flashes or lights when trouble occurs in the VTR section.
LIGHT switch
ON: This illuminates the display window
OFF: This extinguishes the display window illumination.
Display window
The warnings related to the VTR section, remaining battery level, sound level, time data, etc.
are displayed in this window.
– 22 –
is at HIGH or LOW, and it lights during recording
.
when the back tally switch
.
.
'
'
÷
◊
ÿ
—
is set to
Advertisement
Table of Contents
