How To Start A Program - Miele PG 8528 Installation And Operating Instructions Manual

Operating the machine
Opening and closing the door
^ Press the a button.
The door raises up or lowers down.
To open the door on the clean side
(PG 8528), please note the following:
– programs with a process
requirement must have been
completed without fault,
or
– the gate function is activated, i. e.,
door mechanism is set to one of the
following parameters:
- Interlock,
- Door clean + Interlock,
- Door unclean + Interlock.
(see "Programming manual" under
"Machine functions / Continuous
program").
,
If the pre-heater has been
programmed for "Boiler* ready",
always beware of hot water or steam
exiting the open door! Viewed from
the unclean side, the water inlet pipe
for the pre-heater is located beneath
the basket guide rail on the right
side.
* The non-pressure pre-heater is
called "Boiler" in the display.
38

How to start a program

You can find details and important
information regarding the Miele
default programs in the Program
overview chart in the accompanying
"Programming manual".
,
Any program or dispensing
changes in connection with the
preparation of medical devices must
be documented (under the German
Medical Device Operator
Ordinance).
In such cases, the
washer-disinfector results (cleaning,
disinfection) will need to be
re-validated.
If a barcode scanner is connected to
the washer-disinfector and the user
or load scan is activated, the
selected program cannot be started
until scanning is completed.
All work steps in connection with the
barcode scanner are described in
the "Barcode scanner" section.