Operating The Machine; Main Switch; How To Switch On - Miele PG 8528 Installation And Operating Instructions Manual

Main switch

The main switch disconnects the
washer-disinfector from the power
supply.
^ Turn the main switch to I-ON.
Once the start procedure is completed,
the washer-disinfector is ready to
operate.
The following message may appear:
Fault 2218: "New power frequency
60 Hz Flow rate automatically
adjusted" or "New power frequency
50Hz Flow rate automatically
adjusted". During the start procedure,
the Profitronic detected a different
network frequency and adjusted the
flow rate of the dispensing pump
accordingly. Before operation, you
will need to check whether the
change in power frequency was
caused by a fault in the power
supply.
If so, incorrect amounts of
processing chemicals would be
dispensed during the program.
The fault message can only be
confirmed in operating level D and in
service mode.

Operating the machine

How to switch on

^ Hold down the s (ON/OFF) button
for at least 1.5 s.
The actuating time for the s
(ON/OFF) button can be set up to a
maximum of 10 s (see "Programming
manual" for the section on "System
functions / On/Off button activation
time").
Depending on the set operating level,
the following will appear in the display:
Operating Displayed
levels
A and B A list of approved
programs.
C Instructions for Auto-
matic mobile unit
recognition.
D Select from:
– Program overview
– Programming
– Settings J.
If the washer-disinfector is not in use,
the display automatically switches off
after approx. 10 min.
To turn the display back on, press
any button.
37