Pre-Start Inspection - MK Diamond Products MK-2000 Owner's Manual, Operating Instruction

MK-2000 ELECTRIC SAW

PRE-START INSPECTION

Prior to beginning work, a pre-start inspection of the saw should be performed.
(A)
Ensure the ON/OFF switch is in the
OFF position.
(D)
Inspect the Pump Assembly for dam-
age - ensure the cord is free of cracks
or cuts.
CONNECTING THE WATER PUMP
CAUTION
(A)
Connect the Cooling Transfer
Tube to the inlet connection of
the Blade Guard.
Verify the Movable Cutting Table
moves freely along the guide rails.
Inspect the MK-2000 for damage.
NOTE: To prevent pump damage, the Water Pump must be disconnected if
cutting with a Dry Blade.
Connect the Water Pump power
cord to the receptacle found on
(B)
(E)
(B)
motor.
19
SETUP & INSPECTION
D e-b onding
of s egmen t
(C)
Inspect the Diamond Blade for dam-
the blade is correct for the material
being cut.
(F)
Inspect the Wooden Protective Strip
for excessive grooves.
Cra cks