Setup, Adjustment And Operation; Pre-Start Inspection; Connecting The Water Pump - MK Diamond Products MK-101 Operating Instructions Manual

SETUP, ADJUSTMENT and OPERATION

SETUP:

1. Pre-start Inspection:

Prior to beginning work, a pre-start inspection of the saw should be performed.
ON/OFF
Switch
(A)
Ensure the ON/OFF Switch
is in the OFF position
Inspect for
cracks or cuts
Inspect for
damage
(D)
Inspect the Pump Assembly
for damage – ensure the cord
is free of cracks or cuts

2. Connecting the Water Pump:

To prevent the possibility electrical shock, the MK-101 MUST be de-energized when connecting
1.
the Water Pump.
To prevent the possibility of electrical shock, use only MK Diamond qualified replacement parts
2.
NOTE: To prevent pump damage, the Water Pump must be disconnected if cutting with a Dry Blade.
Cooling
Transfer connection
Tube
Press on
(A)
Connect the Cooling Transfer
Tube to the inlet connection
of the Blade Guard
MK-101
Off Verify ease of movement
Position (See Maintenance section
if problems exist)
Verify the Movable Cutting Table
Inspect for
damage
Inspect the MK-101
for damage – ensure the cord
is free of cracks or cuts
Inlet
Connect the Water Pump power
cord to the connection found on
the back of the motor
Revision 4/01, Effective Date April 29, 2001
(B)
moves freely
(E)
Pump
Connection
(B)
Inspect for cracks,
de-bonding, etc.
(C)
Inspect the Diamond Blade for
damage – verify the blade is
correct for the material being cut
Page 15