Table of Contents
Advertisement
MK-370EXP SAW
PRE-START INSPECTION
Prior to beginning work, a pre-start inspection of the saw should be performed.
(A)
Ensure the ON/OFF Switch
is in the OFF position
(D)
Inspect the Pump Assembly
for damage – ensure the cord
is free of cracks or cuts
CONNECTING THE WATER PUMP
WARNING
NOTE:
To prevent pump damage, the Water Pump must be disconnected if cutting dry.
(A)
Loosen the cutting head
pivot retaining knob and tilt
cutting head to 45°
Verify the Movable Cutting
Table moves freely
Inspect the MK-370EXP
Saw for damage – ensure
the cord is free of cracks or
1. To prevent the possibility of electrical shock, the MK-370EXP Saw MUST
be de-energized when connecting the Water Pump.
2. To prevent the possibility of electrical shock, use only MK Diamond
authorized replacement parts.
Connect the Cooling Transfer
Tube to the inlet connection
on the Blade Guard
(B)
(E)
cuts
(B)
26
(C)
Inspect the Diamond Blade for
damage – verify the blade is
correct for the type of material
being cut
(C)
Connect the Water Pump power
cord to the connection found on
the back of the motor
SETUP
Advertisement
Table of Contents
