Installing The Ap; Preparing For Installation; Precautions; Preparing Tools - Tenda i12 User Manual

2

Installing the AP

2.1

Preparing for Installation

Before installing the AP, follow the instructions in this section to make preparation.
2.1.1

Precautions

To prevent damaging the AP or causing a personal injury, pay attention to the following precautions:
 Ensure that the temperature and humidity requirements specified in the following table are met.
Environment
Operating
environment
Storage environment
 Ensure that the AP is mounted on a place free of accumulated water and water drips. Do not install the
AP in a wet environment.

Do not open or remove the housing of the AP.
 Keep the AP clean.

Before cleaning the AP, disconnect it from the power supply. Do not scrub the AP with any liquid.
2.1.2

Preparing Tools

You may need a rubber hammer, a marker, a hammer drill, a spirit level, a measuring tape, a 6 mm drill bit, a
Phillips screwdriver, ESD gloves, and a ladder during installation. Prepare them yourself.
Rubber hammer
Spirit level
Phillips screwdriver
2.2 Installing the AP
Step 1 Place the mounting bracket onto the target position of the ceiling and mark the positions of the screw
Temperature
0°C - 45°C
-40°C - 70°C
Marker
Measuring tape
ESD gloves
Humidity
10%RH - 90%RH (non-condensing)
5%RH - 90%RH (non-condensing)
Hammer drill
6 mm drill bit
Ladder