Placing Calls - NEC UNIVERGE SV8100 DT7 SERIES User Manual

8. PROG TELBK. Use this area to program a telephone directory.
9. PROG - FCTN (Function Programming). Use this area to program buttons on your
phone. For example, to program a button to transfer calls to another phone: Press
Fctn, then press the button you want to program. Then dial 01 (code for
programming one touch buttons). Then press HOLD to write, then dial the extension
number of the phone you want to be able to see status and transfer calls to. Press
HOLD again to write the number. Press speaker to exit. Other codes you might use:
05+Headset; 20=external paging; 21=internal zone paging (Groups 01-64); Internal
all call =22. All codes currently available are listed in the back pages of this guide.
10.PROG, then down arrow to ALM. ALM1 will ring your phone one time to remind
you of an appointment etc. Enter the time in military time. Lift the handset when you
are done. ALM2 will ring your phone every day. To clear ALM2, enter 0000 for the
time.
11. If you have a JOYSTICK control on the bottom right of your phone, press the
center button to see Missed Calls if you have Caller ID.

PLACING CALLS

Internal Calls
1. Lift the handset.
2. Dial a station number or 0 for the attendant. OR Press the button programmed for
Direct Station Select.
3. Voice announce after the tone burst or wait for the ringing call to be answered.
Note 1: When calling a multiline telephone, dialing 1 after the station number will
change ringing to voice or voice to ringing.
6
Outside Calls
1. Lift the handset.
2. Typically dial 9 OR press an idle Outside Line key.
3. Dial the telephone number.
Last Number Redial
1. Without lifting the handset, press the Redial key. The last dialed number is
displayed.
2. To redial the last number, press #. OR Search for the desired number from the
Redial List by pressing the Redial Softkey or VOLUME UP or VOLUME DOWN keys.
3. Lift the handset or press Speaker to place the call.
4