NEC UNIVERGE SV8100 DT7 SERIES User Manual page 2

HOLD. The red HOLD button at the bottom of the phone is used to put calls on hold.
TRANSFER. The TRANSFER button is used to transfer calls to another phone. To
transfer a call, press the TRANSFER button, then dial the extension number of the
phone you want to send the call to. When the person answers, you can either
announce the call or just hang up.
SPEAKER. The SPEAKER button activates the speakerphone.
ANSWER. The ANSWER button is used to answer a second call, like call waiting
CONFERENCE. The Softkey under CONF button is used to set up a conference call by
adding on callers. Press CONF, then dial 9 and another number. After the person
answers, press CONF or the Softkey BEGIN to add them in. Repeat this until all
parties are on the line. As an option, we have a dedicated conference card that will
adjust levels for up to 16 callers.
RECALL. This button can be used to disconnect a call and give you fresh dial tone.
FEATURE. The FEATURE button is used for programming.
MIC. The MIC button turns on/off the built in microphone. Most prefer to leave the
microphone on (light on) so you can use the speakerphone and talk back intercom.
Either UP and DOWN arrows or a Joystick are located at the bottom right of the
phone. Use these buttons to change ring volume, speaker volume, handset volume,
and contrast on the LCD screen, depending on what your phone is doing at the time.
RING VOLUME. Press SPEAKER, then dial 829 to make your phone ring to set the
ring volume using the up and down volume control (arrows or joystick).
SOFT KEYS. The 4 gray buttons just below the LCD screen are called soft keys. These
buttons can be used for a variety of things. Press the Exit button when you are done.
1. List. If you press the LIST button, you can next press the softkey under Redial to
see a list of the last five numbers you dialed. When you see the number you want to
redial, press the Speaker button or pick up the handset. Also, you can see CID (Caller
ID) to scroll through recent calls if you have the caller ID feature.
NEC SV-8100 - User Introduction for Display Phone
2