NEC UNIVERGE SV8100 DT7 SERIES User Manual page 5

Programming One-Touch Inter-Com Keys
1. Press the Speaker key.
2. Dial Service Code 851.
3. Press the Line Key to be programmed. Screen should say "Not Defined" or an old
entry you can erase! Leave CAP Keys in place or you won't be able to transfer calls!
4. Dial 01 followed by the extension number.
5. Press HOLD then Speaker
Station Speed Dial — Programming
To store a Station Speed Dialing number (display telephones only):
1. Press the Speaker key.
2. Dial 855.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2 etc.
Note: 0 = Station Speed Dial buffer 10
4. Dial the Access Code (e.g., 9) - if required.
5. Dial telephone number you want to store (up to 24 digits).
Note: Valid entries are 0~9, # and *. To enter a pause, press MIC. To store a Flash,
press Recall.
6. Press Hold.
7. Enter the name associated with the Speed Dialing number (display telephones
only):
# # = Accepts an entry (only required if two letters on the same key are needed - ex:
TOM). Pressing # again = Space. Conf Clears the character entry one character at a
time (used when entering the Name). EXIT Clears all the entries from the point of the
flashing cursor and to the right (used when entering the Number, this clears both the
number and name).
Speed Dial - System/Group/Station
To dial a Station Speed Dialing number:
1. Press the Speaker key.
2. Dial 814 (default Service Code).
3. Dial the Station Speed Dial buffer number (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2 etc.
Note: 0 = Station Speed Dial buffer 10
To dial a System Speed dialing number:
1. Press the Speaker key.
2. Dial 813 (default Service Code) OR press the Redial Key OR Press the System
Speed Dialing key.
3. Dial the Station Speed Dial buffer number (Default: 000~999).
5