Dns2 Address - Datalogic PowerScan PBT9500 Software Reference Manual

Enter/Exit Programming Mode

DNS2 Address

This is the address of the alternate or secondary DNS server for
BC9180™. This server is used if the DNS server specified as the preferred
DNS server (DNS1) is unreachable or cannot resolve DNS names to IP
addresses for DNS names queried by this
$ETD2
Set DNS2 address
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
DEFAULT
22
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by 8
digits (in hex) from the Alphanumeric characters in
Appendix B, Keypad
character(s).
Exit programming mode by scanning the ENTER/
EXIT barcode again.
Default DNS2 address = 00000000,
hexadecimal representation of 0.0.0.0
DNS2 Address
computer.
representing your desired
~
CANCEL
BC9180™ Base Station/Charger