Working Table - Konica Minolta bizhub PRESS C1100 Quick Manual

L
When a message appears, place the
FD-5BT on the white calibration plate,
then click [OK] while holding it down.
NOTICE
When the FD-5BT is placed on the plate, it does not
come into contact with the white calibration plate.
Securely press down. If there is a gap, the default
adjustment will fail.
M
When the message is displayed, click
[OK] to start the measurement.
N
Prepare the printed chart.
- Place five to 10 blank sheets of the same
color under the printed chart so that it will
not be affected by the color of the working
table.
-
If a ruler is available, align it on the chart.
- To make the measurement, remove the
FD-5BT from the target mask.
O
Carry out the measurement in
sequence from row A.
- Hold down the side button of the FD-5BT.
After a bleep sounds, slide the FD-5BT
while holding down the side button.
After sliding the FD-5BT to the opposite
side, release the side button.
- For details about how to use the FD-5BT,
refer to the manual supplied with this
machine.
bizhub PRESS C1100/C1085
5-31
5