Konica Minolta bizhub PRESS C1100 Quick Manual page 52

5.1 Both Sides Adjustment
F
Press [Exit Print Mode].
G
Measure the gap between the front and
back sides at each point of [a] to [d] on
the [back] side of the printed out chart.
- This figure shows an example to measure [a].
The scale resolution is 0.5 mm.
-
In this figure, the black line indicates the front
side, and the blue line indicates the back
side.
- The measurement value can be entered in
units of up to 0.1 mm.
-
For example, as shown in the figure, if the
scale of [a] is misaligned 1.5 mm in the plus
side compared with the front side, press [1] -
[5] - [+/–] to enter "–1.5" as the adjustment
value. Then, the blue line on the back side
will be moved 1.5 mm toward the minus side.
- Write down the measured values so that you
do not forget them.
5-4