Raymarine E SERIES Installation Instructions Manual page 61

2. Ensure the memory card slot door is in the open
position.
3. Orientate the bottom-right side of the bezel under
the lip of the chart card door and place the bezel
over the front of the display, ensuring that the
clips along the bottom edge of the bezel latch
into position.
4. Ensure the bezel is correctly aligned with the
display, as shown.
5. Apply firm but even pressure to the bezel along
the:
i. Outer edges - work from the sides upwards
and then along the top edge, to ensure that it
clips securely into position.
ii. Inner edges - particularly along the chart card
door edge, to ensure that the bezel sits flat.
6. Check that the Power button and chart card door
are free to operate.
Removing the front bezel
Before proceeding ensure the memory card slot door
is open.
2 2 2 2
1 1
1 1 1 1
Mounting
D12586-1
2 2 2 2
D12584-1
Important: Use care when removing the bezel.
Do not use any tools to lever the bezel; doing so
may cause damage.
1. Place both your thumbs on the upper left edge
of the display, at the positions indicated in the
diagram above.
2. Place your fingers underneath the bezel, at the
positions indicated in the diagram above.
3. In a single firm motion, apply pressure to the
outer edge of the display with your thumbs and
pull the bezel towards you using your fingers.
The bezel should now come away from the display
easily.
61