Enabling/Disabling The Bluetooth Function; Updating The Unit's Firmware - Yamaha YAS-306 Owner's Manual

Enabling/disabling the Bluetooth function

Enable or disable the Bluetooth function.
NOTE
• By default, the Bluetooth function is enabled.
1
Turn off the unit.
2
Hold down the key and press the
CONNECT
The Bluetooth function is enabled, and the unit turns on. For several seconds
immediately after the unit is turned on, the indicator shows Bluetooth function
status.
key on the unit.
Off (disabled), glows (enabled)

Updating the unit's firmware

New firmware that provides additional features or product improvements will be released
as needed. Firmware can be updated using the MusicCast CONTROLLER app installed
on a mobile device.
Cautions
• Do not operate the unit or disconnect the power cable or network cable during firmware update.
• If the Internet connection speed is slow, or the unit is connected to the wireless network, network update
may not be possible depending on the condition of the network connection. Should this occur, try again
at a later time.
• For details on update, visit the Yamaha website.
When a new firmware is released, the "Update new firmware now?" message is
displayed on the MusicCast CONTROLLER app's screen.
1
Tap "Yes".
The firmware update will begin.
A progress bar indicating update progress will be displayed by the app while
firmware is updated. Update progress can also be confirmed using the indicators on
the unit.
Update progress
HINT
• If there are multiple firmware updates, the indicators will start glowing as each firmware update
begins.
• If "Later" is selected, tap (Setup) in the app's room selection screen, and then select "New
firmware is available". Follow the on-screen instructions to update the firmware.
If the update is completed successfully, the "Firmware update completed" message will
be displayed by the app, and all indicators on the unit will flash.
SETTINGS ➤ Enabling/disabling the Bluetooth function
31
En