Remote Control - Yamaha YAS-306 Owner's Manual

Remote control

Problem Cause
The unit cannot be The unit is out of the operating
range.
operated using the
remote control.
The batteries are weak.
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
The TV cannot be
The unit and TV are too far apart
operated when the (or too close), preventing proper
operation of the unit's TV remote
TV's remote control
repeater function.
is pointed toward the
unit's remote control
There are obstacles between the
sensor.
unit and the TV (cables, etc.),
preventing proper operation of the
unit's TV remote repeater
function.
The TV's remote control does not
use infrared signals.
Signals transmitted from the TV's
remote control and the unit's TV
remote repeater interfere with
each other, making it difficult for
the TV to receive signals.
The unit does not The TV's remote control key was
learn TV remote not held down long enough.
control commands.
The TV's remote control does not
use infrared signals. (Some
remote controls may not function
even if it uses infrared signals.)
The TV's remote control is not
pointed at the unit's remote
control sensor.
Remedy
The unit does not
Use the remote control within the
learn TV remote
operating range (p.3).
control commands.
Replace with new batteries (p.3).
Adjust the lighting angle, or
reposition the unit.
Position the unit so that it is more
than 5 cm (2 in) away from the TV
(p.8).
Remove obstacles between the
unit and the TV.
Sound comes from
the TV when the
unit's volume is
increased using the
The unit's TV remote repeater
TV's remote control
function cannot be used.
(when the unit has
Reposition the unit so that it does
been taught TV
not obstruct the remote control
remote control
sensor on the TV, and point the
commands).
TV's remote control at the remote
control sensor on the TV to
When the power key
control the TV.
on the TV's remote
Hold down the key for at least 1 control is pressed,
second and release it for at least power status for the
1 second. Perform this operation
unit and the TV is
twice. If the unit fails to learn
reversed (e.g., when
functions, perform this operation
the unit is turned on,
three times (p.27).
the TV turns off)
(when the unit has
The TV's remote control cannot
be used to teach the unit TV been taught TV
remote control commands. Use remote control
the unit's remote control to
commands).
operate the unit.
Point the TV's remote control at
the unit's remote control sensor
(p.27).
Problem Cause
The batteries of the TV's remote
control are weak.
The remote control sensor of the
unit is exposed to direct sunlight
or strong lighting.
The transmission of the remote
control signal was disturbed by
the TV screen light.
The remote control for the cable
or satellite set-top box is used for
learning.
Audio output is enabled on the
TV.
The power of the TV was on when
you performed the learning
operation.
APPENDIX ➤ Troubleshooting
Remedy
Replace with new batteries.
Adjust the lighting angle, or
reposition the unit.
Turn off the TV (p.26).
Use the TV's remote control for
learning, then use the remote
control for the set-top box to
operate the unit.
Change the TV setting to disable
the TV speaker output. If a setting
to disable the speaker output is
not available on your TV, try the
following methods.
- Connect headphones to the
headphones jack on the TV.
- Set the TV volume to minimum.
Press the power button on the TV
itself to turn on the TV, and press
the key on the unit to turn on
the unit. Then, press the power
key on the TV's remote control to
turn off both the TV and the unit.
35
En