Enabling/Disabling The Bluetooth Function; Updating The Unit's Firmware - Yamaha MusicCast Bar 40 Owner's Manual

Enabling/disabling the Bluetooth
function
Enable or disable the Bluetooth function.
This function is enabled by default.
1
Turn off the unit.
2
Press and hold BLUETOOTH at least three
seconds.
The Bluetooth function is enabled, and the unit turns on.
The indicator shows Bluetooth function status for several
seconds, and then all indicators glow.
NOTE
Press INFO to confirm whether the Bluetooth function is enabled or disabled. For
details, see the following:
▪ "Showing audio information and function settings" (p.34)

Updating the unit's firmware

New firmware that provides additional features or product
improvements will be released as needed. Firmware can be
updated using the MusicCast CONTROLLER app installed on a
mobile device.
NOTICE
▪ Do not operate the unit or disconnect the power cord or network cable during
firmware update.
▪ If the Internet connection speed is slow, or the unit is connected to the wireless
network, network update may not be possible depending on the condition of the
network connection. Should this occur, try again at a later time.
▪ For details on update, visit the Yamaha website.
When a new firmware is released, the "Update new firmware now?"
message is displayed on the MusicCast CONTROLLER app's
screen.
Glows (enabled)
Off (disabled)
47
En