If there are no new messages in the voice
mail, MVMN is not displayed.
R If the handset still indicate there are new
messages even after you have listened to
VM access #
Base no power
No link to base.
base AC adaptor.
Check tel line
to Caller ID.
For assistance, please visit http://www.panasonic.com/help
R You have not stored the voice mail access number. Store the
number (page 41).
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been canceled.
Re-register the handset (page 32).
R The called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The handset you are using is too far from the base unit. Move
closer and try again.
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
R Recording was too short. Try again.
R There is no handset registered to the base unit matching the
handset number you entered.
R The handset is not registered to the base unit. Register the
handset (page 32).
R The phonebook memory is full. Erase unwanted entries
R Message memory is full. Erase unwanted messages
R The call block list memory is full. Erase unwanted entries
R The schedule alarm memory is full. Erase unwanted entries
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 6.
all new messages, turn it off by pressing
and holding # until the handset beeps.