Listening To Messages - Panasonic KX-PRS120 Operating Instructions Manual

Answering System
Playing back the greeting
message
1
MMenuN (right soft key) #303
2
To exit, press MOFFN.

Listening to messages

When new messages have been recorded,
"New message" is displayed on the handset.
1
To listen to new messages:
*1
MPlayN
or
MMenuN (right soft key) #323
To listen to all messages:
MMenuN (right soft key) #324
2
When finished, press MOFFN
*1 If there are no new messages in the
answering system, MPlayN is not
displayed.
Note:
R To switch to the receiver, press M
Listening to messages from the
message list
You can select the item to play back.
1
MMenuN (right soft key) #329
2
MbN: Select the desired item from the
message list. a MPlayN
R You can erase the selected message
as follows:
MMenuN a MbN: "Erase" a MSelectN
a MbN: "Yes" a MSelectN
3
When finished, press MOFFN
Note:
R If the item has already been heard, " " is
displayed, even if it was heard using
another handset.
R "Message" is displayed in the message list
if the unit cannot receive caller information.
For assistance, please visit http://www.panasonic.com/help
36
PRS120(en)_0122_ver110.pdf
Operating the answering system
MMenuN (right soft key) a
N.
*1
*2
*3
*4
Rewinding the message
Press and hold MFN until the unit plays the
desired part of the message.
36
Key Operation
MDN or MCN Adjust the receiver or speaker
volume (during playback)
1 or MFN Repeat message
(during playback)
2 or MEN Skip message
(during playback)
3 Enter the "Settings" menu
4 Play new messages
5 Play all messages
6 Play greeting message
76 Record greeting message
8 Turn answering system on
MPauseN
Pause message
9 or Stop recording
MStopN Stop playback
0 Turn answering system off
Erase currently playing
*4 *4
message
*5 Erase all messages
*6 Reset to a pre-recorded
greeting message
If pressed within the first 5 seconds of a
message, the previous message is
played except when playing back from
the message list.
When you play a message from the
message list, the unit stops message
playback and the display goes back to the
message list.
To resume playback:
MbN: "Playback" a MSelectN
You can also erase as follows:
MPauseN a MbN: "Erase" a MSelectN
a MbN: "Yes" a MSelectN
a MSelectN
*1
*2
*3
2014/01/22 10:09:31