Table of Contents
Advertisement
Error messages
Display message
Base no power
or
No link.
Reconnect
AC adaptor.
Check
Phone Line
Error
Memory Full
Use
rechargeable
battery.
You must first
subscribe
to Caller ID.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's AC
adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset, and then
insert them into the handset again.
If the base unit batteries for power backup are installed, remove the batteries from the base unit, and
then insert them into the base unit again.
General use
Problem
The handset does not turn on
even after installing charged
batteries.
The unit does not work.
The handset display is blank.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
TGF320E(en)_0123_ver020.pdf
51
Cause/solution
R Confirm the base unit's AC adaptor is connected to the unit and
the power outlet correctly.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset's registration may have been cancelled. Re-register
the handset (page 37).
R The supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 10).
R Recording was too short. Try again.
R The phonebook memory is full. Erase unwanted entries (page 25).
R The call block list memory is full. Erase unwanted entries
(page 23).
R A wrong type of battery such as alkaline or manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 7.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Cause/solution
R Place the handset on the charger to turn on the handset.
R Make sure the batteries are installed correctly (page 10).
R Fully charge the batteries (page 11).
R Check the connections (page 10).
R Unplug the base unit's AC adaptor and remove the batteries from
the handset to reset the unit. Reconnect the adaptor, insert the
batteries into the handset and try again.
R The handset has not been registered to the base unit. Register
the handset (page 37).
R The handset is not turned on. Turn the power on (page 15).
Useful Information
51
2015/01/23
18:26:31
Advertisement
Table of Contents
