Table of Contents
Advertisement
Configuring for Manually-Entered Pulse Rate
Configuring for Manually‐Entered Pulse Rate
If your patient will be manually reporting a pulse, you must configure the monitor. Since this reading is
done through manual entry, no pairing is involved.
To configure manually-entered pulse rate:
1. From the General Settings screen, select Peripherals. A Peripherals screen similar to the following
appears:
2. Select the add icon (
). A screen similar to the following appears. Select Pulse Meter:
3. Select Patient to enable the patient to enter their pulse manually:
©
6/9/14
2014 Honeywell HomMed. All rights reserved.
P4810EN.05
25
Advertisement
Table of Contents
