Connection Of Wiring To Terminals - Panasonic PAW560MAH2L Installation Instructions Manual

Section D
No. Name Description
1 L Power supply
2 N Neutral conductor
3 PE Protective earthing
4 1Z-5 Relay 1Z, Pin 5,
Blower out
5 1Z-3 Relay 1Z, Pin 3,
Blower out
6 OP3 CR8-SV80B, OP3,
Pin 1,
Blower protection
7 2Z-7 Relay 2Z, Pin 7,
Blower protection
8 HU1 Humidifier
9 HU2 Humidifier
10 Blind
1 For ECOi and ECO G systems only.
2 For PAW-160MAH2(L) and 280MAH2(L) only. In this case, there are 6 instead of 5 pins.
3 E2 sensor in case of PACi, E3 sensor in case of ECOi and ECO G.
5.5

Connection of wiring to terminals

Connect wiring to the terminals according to the following instructions.
Stranded wire
1. Cut the wire end with cutting pliers, then strip the insulation to expose the stranded wiring
about 10 mm and tightly twist the wire ends.
2. Using a flat-blade screwdriver, loosen the terminal screw(s) on the terminal plate.
3. Attach a wire-end sleeve to each stripped wire end using a crimping tool.
Section E
Note No. Name Description
230 V AC / 1 U1 (OC) IU/OU
max. 1 A communication
230 V AC / 2 U2 (OC) IU/OU
max. 1 A communication
3 R1 Needed for group
wiring
max. 230 V AC 4 R2 Needed for group
/ 5 A wiring
max. 230 V AC 5 M1-1 For expansion valve
/ 5 A
230 V AC 6 M1-2 For expansion valve
230 V AC 7 M1-3 For expansion valve
max. 230 V AC 8 M1-4 For expansion valve
/ 3 A
max. 230 V AC 9 M1-5 For expansion valve
/ 3 A
10 M1-6
2
Wire-end
sleeve
Section F
Note No.
5 V AC
5 V AC
16 V DC
1
16 V DC
1
12 V DC
1
12 V DC
1
12 V DC
1
12 V DC
1
12 V DC
1
12 V DC
Electrical Wiring
Name Description
1 E1-1 E1 sensor
2 E1-2 E1 sensor
3 E2-1 / E2 sensor (PACi) /
E3-1 E3 sensor
3
4 E2-2 / E2 sensor (PACi) /
E3-2 E3 sensor
3
5 M2-1 Spare, not used
6 M2-2
7 M2-3
8 M2-4
9 M2-5
10 Blind
Note
5 V DC
5 V DC
5 V DC
5 V DC
55