Electrical Wiring
4. Place the wire-end sleeve into the socket on the connector and replace and tighten the re-
moved terminal screw using a flat-blade screwdriver.
Wire-end sleeve
Shielded wire
1. Remove cable sheath not to scratch braided shield.
2. Unbraid the braided shield carefully and twist the unbraided shield wires tightly together.
Insulate the shield wires by covering them with an insulation tube or wrapping insulation tape
around wire.
3. Remove insulation of signal wire.
4. Attach wire-end sleeves to the signal wires and the shield wires insulated in step 2 using a
crimping tool.
5. Connect the shield for the inter-unit control wiring to ground.
56
Screw
Special washer
Terminal plate
Wire
Insulation tape
Insulation tape
Screw and special washer
Wire
Wire-end sleeve
Shield mesh
Shield mesh
Wire-end sleeve