Installation; Installation Of Ahu Kit - Panasonic PAW560MAH2L Installation Instructions Manual

4

Installation

4.1

Installation of AHU Kit

WARNING
Electric shock from live power supply cords
Electric shock may result from contact with live power supply cords.
► Wiring installation must only be performed by a qualified electrician.
► Before starting to work on any machines or devices, always switch off the power
supply and lock it in switched-off position.
!
NOTICE
Damage to the AHU Kit enclosure and to the thermistor and/or expansion valve wires
Exposing the AHU Kit enclosure to direct sunlight can cause overheating and material damage
and should therefore be avoided.
Exposing the wires of thermistors or, in case of the ECOi and ECO G systems, of the expansion
valve to the outside and/or to direct sunlight might damage the wires and should therefore be
avoided.
► Attach the AHU Kit either directly to the Air Handling Unit or to a wall nearby and
make sure that it is not exposed to direct sunlight.
► Use protecting wire ducts to avoid exposing the wires of thermistors and the
electronic expansion valve to the outside.
Mount the AHU Kit according to the following instructions. Please note that screws and other
fixing materials, which may be required, are not included in the kit.
1. Prepare the 4 holes in the wall or on the surface, where you want to mount the enclosure,
using the dimensions shown below (distance between centre points of the holes: 254 mm).
254
Installation
37