Makita JV0600 Technical Information page 8

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Slider section, Toolless Blade Clamp Mechanism
DISASSEMBLING
(1) Disassemble Lever 8, Base, Housing cover, Safety wire as illustrated in Fig. 2. And then, remove Housing set (R)
as illustrated in Fig. 3.
(2) Take out Slider section as illustrated in Fig. 4.
(3) The Slider section can be disassembled as illustrated in Fig. 11.
Fig. 11
1. Separate Rod assembly
from Slider by taking off
Stop ring E-3 and Pin 4.
Stop ring E-3
(4) Rod assembly (Toolless blade clamp mechanism) is disassembled as illustrated in Fig. 12.
Fig. 12
1. Remove Dust cover from
Insert holder.
Retaining ring R-13 in
Insert holder comes into
your sight.
Dust cover
Retaining
ring R-13
4. Now rod assembly (Toolless blade clamp mechanism) is disassembled as illustrated below.
Rod
2. Remove Slider guide from
Slider. And Slider support,
Seal plate are removed from
Rod assembly.
Slider
Pin 4
Rod assembly
2. Remove Retaining
ring R-13 from the
inside of Insert holder
as illustrated below.
1R381
Retaining
ring R-13
Insert
holder
Compression spring 4
Lock pin
Pin 2
Torsion spring 10
Slider guide
Slider
Slider support
Seal plate
Rod assembly
3. Standing Rod assembly
1R173
Work table
Insert holder
Urethane sponge sheet
can be removed from
Seal plate.
Urethane
Sponge sheet
Seal plate
on the work table, push
down Insert holder as
illustrated blow.
Insert
holder
P 8/ 12