Makita JV0600 Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Housing
DISASSEMBLING
(2) Housing set (R) is separated from the Machine. See Fig. 3.
Fig. 3
6. Now Housing set (R) can be separated
from Housing set (L), by unscrewing
ten 4x18 Tapping screws.
(3) After the above step, the inner parts (Carbon brush, Field, Armature, Gear complete, Slider, Rod, etc.) can be replaced.
ASSEMBLING
Take the reverse step of Disassembling. Refer to Fig. 3, Fig. 2.
[3]-2. Crank Mechanism
DISASSEMBLING
(1) Remove Housing set (R). See Fig. 2, Fig. 3.
(2) Disassemble Slider section as illustrated in Fig. 4.
Fig. 4
1. Remove Leaf spring.
And then, take off Slider
guide.
Leaf spring
Slider guide
2. Turning Armature, move Crank pin of Gear
complete to the highest point from the edge
of Housing set (L), as illustrated below.
So, Slider section can be removed easily.
Crank pin
with Sleeve 7
4x18 Tapping screws
( 10 ocs. )
Housing set (R)
Housing set (L)
3. Disassemble Slider section, by
separating it from Sleeve 7.
Slider section
Sleeve 7
P 4/ 12