Makita JV0600 Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-2. Crank Mechanism
DISASSEMBLING
(3) Crank section and Armature are separated from the Housing set (L). See Fig. 5.
Fig. 5
4. Disconnect Carbon brush
from Commutator.
(4) Disassemble crank section as illustrated in Fig. 6.
Fig. 6
6. Remove Flat washer 10,
Sleeve 7, Needle gauge 407
from Crank pin of Gear
complete.
Crank pin of
Gear complete.
9. Remove Armature with 1R269 from Bearing case complete.
Crank section
7. Gear complete, Balance plate,
Push plate, Bearing case complete
are secured with Retaining ring S-6.
So, remove the Retaining ring S-6.
Sleeve 7
Flat washer 10
Needle
Gauge 407
Bearing case
complete
1R269
Armature
8. From Bearing case complete, Push
plate, Balance plate and Gear complete
are separated.
Retaining
rig S-6
Flat washer 6
Bearing case
complete
Armature
P 5/ 12
5. Remove Armature
and Crank section
at a time.
Push plate
Balance plate
Gear complete