Makita JV0600 Technical Information page 10

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Slider section, Tool less Blade Clamp Mechanism
ASSEMBLING
(2) Assemble Toolless mechanism to Slider (Fig.14).
Fig.14
1. Set Poly urethane sponge
seal into Slider plate.
4. Assemble the Rod to Slider while facing the Bore side of Rod to Armature side.
Note: Blade clamp mechanism (Rod assembly) must be mounted to Slider as per illustrated direction.
Stop ring E-3
Bore
2. Assemble Slider plate to Rod.
Note: Locate the closed end of Slider plate
to right side viewing from the bore side of Rod.
Slider plate
Slider
Pin 4
Armature side
Housing R side
Bore
5. Mount Slider guide.
Housing L side
Safety wire side
(Font side)
P 10/ 12
3. Assemble Slider
support.