Toshiba e-STUDIO 160 Service Manual page 75

PFP
With the PFP installed, if paper feed from the PFP is selected, the PFP paper feed sensor Upper
(Lower) sensor detects the presence or absence of paper. The one in parentheses applies when
the cassette module is installed. Press the START button to turn ON the PFP clutch motor to pick
up the paper. At this time, if the PFP paper feed sensor Upper (Lower) sensor does not turn ON
for a fixed time, PFP miss feed will be assumed and the message "Misfeed in copier" will be
displayed.
Reset procedure : Open the PFP cover or copier side cover and remove the jammed paper.
B)-2 Clear misfed document
With the optional ADF or RADF installed, this message is displayed when a document jam has occurred.
Reset procedure : Open the ADF cover or RADF cover and remove the jammed document.
B)-3 Toner empty
When a fixed number of sheets are printed after a Toner Low state has been detected, a Toner Empty
state will be assumed to stop the printing. If a Toner Empty state occurs, printing cannot be performed
until toner is supplied.
Reset procedure : Supply toner.
B)-4 Check process
This message is displayed when some trouble has occurred in the process unit. It is also displayed
when the life of the process unit has been reached.
Reset procedure : Remove and install the process unit or replace it.
C) Call for service
If this message is displayed, none of the operations can be performed. When you press the CLEAR/
STOP key and 8 key at the same time while the message is displayed, the error code will appear on the
display. The explanation of the error code is written in the "SERVICE HANDBOOK."
e-STUDIO160/200/250 COPIER OPERATION 4 - 8 December 2002 TOSHIBA TEC