Toshiba e-STUDIO 160 Service Manual page 210

[G] Heater lamp U900/heater lamp E400/500
1. Remove fuser unit. (See Fig. 14-7-1)
2. Remove heater thermistor. (See Fig. 14-7-2)
3. Remove the housing assembly.
(See Fig. 14-7-10)
4. Remove the heat roller separator.
(See Fig. 14-7-8)
5. Release the heater cover assembly.
(See Figs. 14-7-14)
6. Remove one screw and release the clamp.
7. Remove the heater lamp holder.
(See Fig. 14-7-19 and 14-7-20)
8. Remove the heater lamp.
[CAUTION]
Never touch the heater lamp with your bare hands.
Note: For the ASD/AUD/CND/MJD models, the
400W heater lamp should be attached to
the upper side.
e-STUDIO160/200/250 FUSER UNIT/PAPER EXIT UNIT
e-STUDIO160 series
Clamp
e-STUDIO200/250 series
Clamp
NAD/SAD models
ASD/AUD/CND/MJD models
14 - 16
Screw
Fig. 14-7-21
Screw
Fig. 14-7-22
Heater lamp
Heater lamp harness
(Black)
Fuser thermostat
harness (White)
Fig. 14-7-23
Heater lamp
Heater lamp harness
(White)
Heater lamp harness
(Black)
Fuser thermostat
harness (White)
Fig. 14-7-24
December 2002 TOSHIBA TEC
093-2
093-3
094-5
094-6