Toshiba e-STUDIO 160 Service Manual page 158

[D] Pickup assembly
1. If an ADU (MD-0101) and/or SFB (MY-1016)
are attached to the copier, detach it.
2. Remove paper cassette. (See Fig. 2-6-11)
3. Remove upper right cover R and lower right
cover R. (See Fig.2-6-14)
4. Remove separation holder assembly.
(See Fig. 9-7-1)
5. Remove 2 screws and remove pickup assem-
bly.
[E] Pickup feed roller
1. If an ADU (MD-0101) and/or SFB (MY-1016)
are attached to the copier, detach it.
2. Remove paper cassette. (See Fig. 2-6-11)
3. Remove upper right cover R and lower right
cover R. (See Fig.2-6-14)
4. Remove separation holder assembly.
(See Fig. 9-7-1)
5. Remove pickup assembly. (See Fig. 9-7-4)
6. Remove stop ring and remove pickup feed
roller.
[F] Pickup roller
1. If an ADU (MD-0101) and/or SFB (MY-1016)
are attached to the copier, detach it.
2. Remove paper cassette. (See Fig. 2-6-11)
3. Remove upper right cover R and lower right
cover R. (See Fig.2-6-14)
4. Remove separation holder assembly.
(See Fig. 9-7-1)
5. Remove pickup assembly. (See Fig. 9-7-4)
6. Release 2 hooks.
7. Release timing belt 124 and remove pickup
roller shaft assembly.
8. Detach E-ring and remove pulley and clutch.
9. Detach 2 E-rings.
December 2002 TOSHIBA TEC
Screw
Pickup feed roller
Stop ring
E-ring
Pulley
E-ring
9 - 11 e-STUDIO160/200/250 PAPER FEEDING SYSTEM
Pickup assembly
Fig. 9-7-4
Clutch
Fig. 9-7-5
Pickup roller shaft
assembly
Timing belt 124
Fig. 9-7-6
Pickup roller shaft
Clutch
Fig. 9-7-7
072
073
080
081