Toshiba e-STUDIO 160 Service Manual page 40

[R] Exit cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate and junction block.
2. If a JSP (MJ-5001) or OCT (MJ-5002) is
attached to the copier, detach it.
3. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, open it.
4. If an ADU (MD-0101) is attached to the copier,
open it.
5. Detach scanner cover. (See Fig. 2-6-3)
6. Detach control panel front cover.
(See Fig. 2-6-6)
7. Detach control panel bottom cover.
(See Fig. 2-6-7)
8. Detach front frame covers F and R.
(See Fig. 2-6-18 and 2-6-19)
9. Remove stop ring and detach exit cover.
[S] Inner cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate and junction block.
2. If a JSP (MJ-5001) or OCT (MJ-5002) is
attached to the copier, detach it.
3. Remove one screw holding the top cover L.
4. Remove 2 screws holding the left cover R.
5. Detach ozone cover. (See Fig. 2-6-9)
6. Detach paper tray cover. (See Fig. 2-6-10)
7. Open side cover. (See Fig. 2-6-18)
8. Open exit cover. (See Fig. 2-6-18)
9. Remove one screw, release 4 hooks, and
detach inner cover.
December 2002 TOSHIBA TEC
Top cover L
Left cover R
Screw
Inner cover
2 - 27 e-STUDIO160/200/250 OUTLINE OF THE MACHINE
Stop ring
Exit cover
Fig. 2-6-20
Screw
Inner cover
Screw
Fig. 2-6-21
019
020