Table of Contents
Advertisement
When you select this function, the following message will appear
at the center of the screen to assist you in creating a password.
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD BIOS DEFAULTS
LOAD SETUP DEFAULTS
ESC: Quit
F10:Save & Exit Setup
Type the password, up to eight characters in length, and press
<ENTER>. The password typed now will clear any previously
entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press
<ENTER>. You may also press <ESC> to abort the selection and
not enter a password.
When a password has been enabled, you will be prompted to enter
it every time you try to enter the setup utility. This prevents
unauthorized use of the utility on your computer.
To disable a password, just press <ENTER> when you are prompt-
ed to enter the password. A message will confirm the password
will be disabled. Once the password is disabled, the system will
boot and you can enter the utility freely.
68
SBC-551/552 User Manual
R O M P C I / I S A B I O S ( 2 A 5 I I A K 9 )
C M O S S E T U P U T I L I T Y
A W A R D S O F T W A R E , I N C .
ENTER PASSWORD:
Change / Set / disable Password ....
INTEGRATED PERIPHERALS
SUPERVISER PASSWORD
USER PASSSWORD
IDE HDD AUTO DETECTION
HDD LOW LEVEL FORMAT
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
: Select Item
(Shift)F2:Change Color
Advertisement
Table of Contents
