Aaeon SBC-551 Manual page 72

Internal PCI/IDE
IDE Primary Master PIO
IDE Primary Slave PIO
Primary Master UltraDMA : Auto
Primary Slave UltraDMA
IDE Burst Mode
IDE Data Port Post Write
IDE HDD Block Mode
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port2
IR Address Select
IR Mode
IR IRQ Select
Onboard Parallel Port
Parallel Port Mode
PS/2 mouse function
IDE Primary / Master / Slave PIO
This sets the hard disk PIO transfer mode, which affects the hard
disk data transfer rate. The system will auto-detect the PIO mode
of a device in any of these positions when they are set to Auto, the
recommended setting. Alternatively, you can set the mode
manually. Modes 0 to 2 are supported.
Primary / Master / Slave UltraDMA
This sets the transfer mode of the UltraDMA hard disk, which
requires a drive that supports this data transfer method. The
system will auto-detect an UltraDMA device in any of these two
positions when they are set to Auto without effect if there are no
UltraDMA devices installed.
64 SBC-551/552 User Manual
R O M P C I / I S A B I O S ( 2 A 5 I I A K 9 )
I N T E G R A T E D P E R I P H E R A L S
A W A R D S O F T W A R E , I N C .
: Primary
: Auto
: Auto
: Auto
: Disabled
: Enabled
: Enabled
: Enabled
: 3F8H
: 2F8H
: Disable
: HP SIR
: IRQ10
: 378
: SPP
: Enabled
USB Controller
USB Keyboard Support
Esc:Quit
F1 : Help PU/PD/+/-: Modify
F5 : Old Values (Shift)F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
: Enabled
: Disabled
: Select Item