Registration - MagicBox Torque User Manual

R E G I S T R AT I O N
Up to 5 handsets can be registered to the Torque
base. Additional handsets must be fully charged and
registered to the base before you can use them.
NOTE
If you have purchased a Torque multipack, any
additional handsets in the box will already have
been registered to the base and you will not need to
register them.
• The instructions described below apply specifi cally to
your Torque handset. If you wish to register another
manufacturer's handset, the instructions may vary.
In this case, please refer to the manufacturer of the
additional handset.
• The Master PIN is required before you can register or
de-register handsets. The default PIN is 0000.
To register a handset
At the base:
1. Press and hold the
underneath the Torque base, for at least 3 seconds
until you hear a double beep. You have 60 seconds in
which to register your additional handset.
Torque User Guide.indd Sec1:35 Torque User Guide.indd Sec1:35
button, which can be found
At the handset:
2. If the handset is new and 'Please Register' is
displayed. Press 'Menu' . 'Registration' is displayed'
press 'Select'
Or
If the handset has already been registered to another
base the standby display is shown. Press 'Menu' , scroll
or to 'Registration' and press 'Select' .
3. 'Register Handset' is highlighted, press 'Select' .
4. Bases are displayed. If necessary scroll
a new base you wish to register your handset to and
press 'Select' .
5. Enter the System PIN (original PIN is 0000) and
press OK.
6. 'Searching Base X' (where X is the chosen base
number) then 'Handset Registered' is displayed.
The handset is automatically assigned the next
available handset number eg: 2.
35
or to
5/2/10 17:14:30 5/2/10 17:14:30